ServicesRoof Repair
Roof Repair in Paradise Valley
A stain on the ceiling or a slipped tile doesn't usually mean you need a new roof. We trace the leak to where it starts, fix that spot properly and tell you plainly what code asks of the work. Many repairs take just one visit.
Fixing the cause, not just the drip
Water rarely comes in where you see it. It can run along a rafter or under a tile course for several feet before it shows on drywall. So the first part of every repair is finding the true entry point: a cracked tile, a lifted flashing, a split in a flat roof coating or a worn pipe boot.
Our sun is hard on roofs. Years of heat and UV dry out underlayment, bake sealants until they crack and wear down shingle granules. A good repair replaces the failed material with something rated for this heat, not a dab of caulk that lets go next summer.
We are an Arizona KB-2 licensed contractor, and we treat code as part of the repair rather than an afterthought. If a fix grows large enough to need a permit, you hear that from us before any work starts.
What a roof repair with us covers
Leak tracing
We check the roof surface and, when there's attic access, the underside of the deck too. Every problem spot gets photographed, and we go over the pictures with you before talking about fixes.
Tile reset and replacement
Cracked or slipped concrete and clay tiles get replaced or reset. If the underlayment beneath is brittle, we show you and explain the options before going further.
Flashing and penetrations
Chimney, wall and valley flashing, plus pipe boots and vent collars, are common failure points. We reseal or replace them with materials made to handle high roof temperatures.
Flat and foam roof patches
Splits, blisters and ponding spots on flat sections are cut out, patched and recoated so the repair bonds with the existing surface.
Shingle repairs
Missing, curled or granule-bare shingles are swapped out and sealed down, matched as closely as available stock allows.
Cleanup and a clear record
We pick up old tile pieces, nails and debris before we leave, and you get a written note of what we fixed.
When a roof is asking for repair
Marks on ceilings or walls
A yellow-brown ring or paint that starts to blister tells you water is reaching the inside of your home. Tracing it early saves drywall and insulation.
Cracked or slipped tiles
A broken tile exposes the underlayment to direct sun, which speeds up its breakdown. One or two cracked tiles are a simple fix if caught early.
Water pooling on a flat roof
Ponding that sits more than a couple of days after rain stresses coatings and finds weak seams.
Granules in the drainage
Sandy grit collecting at downspouts or on the ground below the eaves means shingles are wearing thin.
Daylight or damp spots in the attic
Light through the deck or dark, damp patches on the wood point to an opening that will get worse.
How a repair visit works
- 1
A phone conversation
You tell us what you're seeing and where. We ask a few questions about the roof type and age so we arrive with the right materials.
- 2
Finding the source
On site, we trace the leak and photograph what we find. Then we explain what it needs, whether a repair makes sense or the roof is past patching.
- 3
Written scope and code check
You get the work in writing before we start. Small repairs usually don't need a permit. If yours does, we pull it and schedule the town's inspection ourselves.
- 4
The repair and cleanup
We protect landscaping and walkways, make the fix and clean up. Afterward we walk you through what we did with before and after photos.
What moves the price of a repair
We can't put a fair number on a leak until we've found its source, so your price comes in writing after the visit, not as a guess over the phone. These are the things that shift it most.
- Roof material
- Tile repairs take careful lifting and resetting, and matching older tile profiles can take time. Shingle and foam patches are usually quicker.
- What's underneath
- If the underlayment or decking below a leak has failed, that section has to be replaced along with the surface.
- Size and access
- A single pipe boot costs far less than a long valley. Steep pitches and second-story roofs need extra safety setup.
- Code and inspection steps
- Larger repairs that require a permit add a fee and a town inspection. We tell you up front if that applies.
Roof repair questions
Something not covered here? (480) 485-3889
Do I need a permit for a roof repair?
Most small repairs, like replacing a few tiles or resealing flashing, don't need one. Bigger jobs that replace decking or a large area of underlayment can. We tell you which applies to your repair and take care of the paperwork and town inspection when it's required.
Can you just patch it, or will I need a new roof?
Many roofs only need a targeted fix, and we'll say so. If the underlayment is failing across the whole roof, repeated patches stop making sense, and we'll explain why with photos. Our Roof Replacement page covers what that involves.
Is the repair work covered?
Yes. Our repairs come with a 10-year labor warranty. If our workmanship fails within that time, we come back and make it right.
Can you match my existing tiles?
We match profile and color as closely as current stock allows. Some older tiles are discontinued, so we may pull matching tiles from a less visible spot and put the new ones there.
Will the repair take long?
Small fixes like a pipe boot or a handful of tiles usually take a few hours. Larger sections, or work that has to wait on a town inspection, run longer. Either way, the schedule is in writing before we begin.
Get that leak traced and fixed
Give us a call and describe what's happening at your home. We'll arrange a visit, show you the cause and put the fix in writing before anything starts.